Ask Driving Genie AI
Close

SK Air Brake Test 2 2025

Based on the 2025 SK CDL manual
Questions: 50
Mistakes allowed: 10
Passing score: 80%
Ensuring the accuracy and quality of our practice tests is paramount. Learn more about our rigorous standards in our Commitment to Accuracy article.

A commercial truck driver’s licence is required to drive any commercial vehicle in Saskatchewan. There are two types of driving jobs available: owner-operator and employee. If you plan on running your own business or becoming a driver-for-hire, you will need a truck driver’s licence. To receive a trucking licence, you will have to pass two exams: a commercial knowledge exam with multiple-choice questions and a road test, which will test your general driving skills. To help you study for the knowledge test, we have prepared this second practice exam with 50 questions to test your knowledge of driving large vehicles in Saskatchewan. We encourage you to read the hints and explanations provided and check out our sources. You will notice that the questions are slightly more difficult. This is because they start to examine some of the more technical definitions and concepts found in the official 2025 SK commercial driver’s manual. Once you have studied these questions, giving another truck driver practice test a try may be a good idea. Good luck!

4.5 out of 5 • 2 votes.
Based on 2025 SK commercial driver's license manual
Instant feedback
Unlock all questions with Premium
List of questions (classic view)
  1. If there is a loss of pressure in the trailer supply line, you would expect the trailer brakes to be applied and
  2. If the air pressure reaches 150 psi, the safety valve will open. Where is the safety valve located?
  3. The low air warning device must activate by the time that tank air pressure falls to
  4. Tank air pressure must not drop below _______ while the vehicle is in operation.
  5. Minimum governor cut-out pressure is
  6. When you test the system air-loss rate of a bus or straight truck, the maximum acceptable leakage rate is 3 psi within
  7. Maximum governor cut-out pressure is
  8. When you test the system air-loss rate, the maximum acceptable leakage rates per minute for a straight truck, a tractor pulling one trailer, and a tractor pulling two trailers are
  9. With the engine idling at _________, air pressure must rise from 85 to 100 psi within two minutes.
  10. Minimum governor cut-in pressure is
  11. The governor cut-in pressure is normally _________ below the cut-out pressure.
  12. Air pressure must rise _____________ with the engine idling at 600–900 rpm within 2 minutes.
  13. Before starting the air brake practical test, make sure that air pressure is at least
  14. The spring brakes may begin to drag when the air pressure falls below
  15. A tractor-trailer with one trailer will fail the air-loss rate test if the loss rate exceeds
  16. The trailer air supply valve will close automatically if air pressure in the trailer supply line drops to
  17. A tractor-trailer with two trailers will fail the air-loss rate test if the loss rate exceeds
  18. Before beginning the air-loss tests of the air braking system, make sure that the air pressure has risen to
  19. The air-loss rate test can be performed only when
  20. Air compressors can either be driven by the engine belt and pulleys or
  21. The spring brake test is passed if the vehicle
  22. Different sizes of brake chamber on the same axle can cause
  23. To test the air brakes, the vehicle should be parked
  24. In a drum brake, the brake linings are attached to
  25. Where is the air dryer located?
  26. When draining the air tanks, you observe excessive oil coming out of the supply tank. Which of the following is most likely to be faulty?
  27. You can usually make a normal stop by applying no more than
  28. The coil spring in most spring parking brake chambers can exert a force of
  29. Spring parking brakes typically require air pressures of at least _______ to completely release.
  30. In the air service circuit, there is a double (two-way) check valve connected to the primary and secondary service tanks. What does this valve do?
  31. Wedge brakes are designed to be
  32. Where are the air brake chambers located?
  33. What does an ABS system do?
  34. When you are going at twice the speed, your service brakes will need to work _________ to stop your vehicle.
  35. Which of these significantly decreases the braking force produced at the wheel?
  36. Which type of trailer can be towed before the service tanks are full?
  37. In determining how well your air brake system works, which is NOT a significant factor?
  38. In large commercial vehicles, most air brake systems use automatic valves to
  39. Where are a vehicle's air tanks located?
  40. What is the "cut-in" level?
  41. How can you check whether the trailer spring brakes have activated?
  42. Which of these vehicles is most likely to be equipped with air brakes?
  43. Where is the air pressure gauge for the service tanks?
  44. Which colour is the trailer supply line?
  45. What can cause the air pressure in the air brake system to drop?
  46. How do you apply the parking brakes?
  47. Your vehicle's air compressor is belt driven. How do you check for correct belt tension?
  48. Which of these is not a part of a drum brake?
  49. When brakes become overheated, they also become
  50. What is a "glad hand"?